High Density Discharger Installation Instructions
Working Theory. The Chemical gases, most of which are xenon and iodides, are filled the quartz tube of the light. Through the ballast, then the voltage of 12V DC will be increased to 23KV immediately: the electrons of the xenon in the tube will be dissociated because of the voltage swing and thus an electrical arc happens between the two poles. Xenon light is power saving, safe and has long life, high luminance. In addition of the use of the UV-cut quartz tube, the light is crystal forever.
Safety instruction.
Its unique safety design: Driving safely can be enhanced greatly for the light is equipped with short-circuit protection device, contra-pres- sure protection design. Therefore, the light has been the favour of the automobile modification fans from Europe, U.S.A., Japan, South Korea and Southeast Asia etc.
Installation instruction.
1. Turn off the switch, open the lid of the engine after the engin gets cool, install the same type of HID bulbs in the discharg light group to take the place of the original halogen bubls and then plug all wire cables attached into the socket and ballast related. It is prohibited to touch the surface of HID bulb by hand. If it is dirty, it should be cleaned with the rag.
2. Changing the fuse in the electric circuit of the car into the fuse special for HID.
3. Beforeinstallation, check if the bulb can touch the inner cover of the light or the opening is too small. If so, install after proper adjustment.
4. Put the bulb into the light cover carefully with no damaging force, and then stabilize it and put the waterproof ring to the original.
Get pdf High Density Discharger Installation Instructions
