Alert RS-110 Manual
The T-Harness is an optional accessory designed to cut the install time of the remote starter by 50% or more. Each T-Harness is manufactured specifically for your vehicle. The T-Harness will eliminate any wire splicing needed to make the remote starter operational. The T-Harness will plug in between the vehicles ignition switch then directly to the remote starter control module.
Note: When using a T-harness the following wires must be hooked up from the sixteen pin harness.
1. Black Wire (ground)
2. Blue with Black Stripe Wire (brake input)
Additional Note: Vehicles with an anti-theft system will also require a bypass module. (Part#791)
To operate your test probe, connect the BLACK clip to a good chassis ground. Connect the RED clip to a good 12V positive source. If you cannot locate a 12V positive source, it will be necessary to first use the test probe with just the BLACK clip to a good chassis ground, then probe the ignition harness for the 12V positive source. Make sure the key is out of the ignition switch prior to probing these wires. If the RED light on the test probe illuminates, this is a 12V positive source. Strip this wire back and then clip the RED clip to this wire. When the test probe is connected correctly, both the RED and the GREEN lights will be dimly illuminated. If a positive source is probed, the RED light will glow brightly and the GREEN light will go out. If a negative, or ground, source is probed, the GREEN light will glow brightly and the RED light will go out.
Get pdf Alert RS-110 Manual
