AT 500 Instruction Manual
MOUNTING THE AT 500 TO YOUR BENCH
Place your AT 500 on the edge of a sturdy bench or table where you plan to mount it. Give yourself about 12 inches of work space on each side of the machine to allow room for components.
Using the machine itself as a template, mark and drill four 1/4” holes in your bench and bolt your AT 500 securely to it.
Avoid using wood or lag screws to mount your reloader to the bench. These types of screws can loosen over time.
Changing Shellplate Position
Your AT 500 is shipped with the “universal” shellplate installed. The “universal” shellplate has four shellholder slots: #1, #2, #3 and #5. This allows you to reload a wide variety of calibers.
All AT 500 reloaders are shipped with the #1 slot visible. If the caliber you wish to load requires one of the other slots on the shellplate (see the caliber conversion chart on page 3 to be sure), you may change this by first loosening the brass-tipped set screw (Figure 5) at the top left side of the shaft, just below the shellplate platform, with the supplied 1/8” hex wrench.
Get pdf AT 500 Instruction Manual
