Ground Control Coil Over Conversion Install
Rear:
1. Raise and properly support back of car. I used a long metal bar that I had which reached across from one of the lower A-arms to the other and jacked up in the middle. I then put jack stands under the rear jacking points using jacking pucks.
2. Remove wheels
3. On the passenger’s side of the car you will need to remove the brake pipe bracket so that the suspension can be lowered. It is attached by 2 10mm nuts.
4. Support the lower control arm using a jack and remove the lower shock mounting bolt (21mm). Lower the jack and put it under the cradle.
5. Remove the 2 cradle to body mounting bolts and washers. The Front is 24mm and the rear is 21mm.
6. Low the cradle enough to remove the coil spring
7. Remove the rear seat by pushing rearward and pulling up on the front of the seat bottom on both the drivers and passengers side of the car. The seat bottom can then be removed from the car. There are 4 nuts that need to be removed from the bottom of the seat back inside the car and 4 nuts that need to be removed from the top of the seat back in the trunk.
8. Lift the sound proofing to expose the top shock mount nuts and remove the 2 outer nuts which will allow you to remove the shock.
9. After removing the shock from the car disassemble the top of the shock by removing the remaining nut.
10. Assemble the top of the shock per the GC sketch adding the new parts.
Get pdf Ground Control Coil Over Conversion Install
