1999-2004 Peugeot 206 GTi/CC K&N Drycharger Installation Instructions
TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip and remove the intake hose from the throttle body housing.
3. Carefully lift the air box out of the mounting grommets and remove from the vehicle.
4. Taking the necessary safety precautions raise the front of the vehicle and support it with axle stands.
5. Remove the wheel arch liner from the vehicle by removing the two screws and clips.
6. Remove the original air box intake hose from the vehicle.
7. Unbolt & remove the air box mounting bracket from the vehicle.
8. Fit the rubber vibration mount to the original slotted hole in the front panel using an M6 washer & nylock nut supplied. Do not fully tighten yet!
9. Fit the mounting bracket to the rubber vibration mount using the M6 nylock nut & washer supplied. Do not fully tighten yet!
10. Fit the stepped silicone hose onto the throttle housing using the #275 barrel clamp supplied. To tighten the barrel clamp, use the small 9/64” wrench provided
11. Fit the ‘A’ tube into the stepped silicone hose and secure using a #300 barrel clamp supplied. Do not fully tighten yet! Before installation, make sure that the insides of both tubes are clean and clean as necessary!
12. Fit the silicone hump hose onto the end of tube “A” using a #300 barrel clamp supplied.
13.Fit tube ‘B’ into the hump hose using a #300 barrel clamp supplied. Do not fully tighten yet!
14. Align the bracket with the welded-on threaded stud on tube ‘B’ and secure using the M6 bolt, washer and waved washer supplied. Do not fully tighten yet!
15. Align the tubes for best fit & clearance and now firmly tighten the barrel clamps, M6 nylock nut and the M6 bolt.
Get pdf 1999-2004 Peugeot 206 GTi/CC K&N Drycharger Installation Instructions
