2003-2007 Honda Element Bracketron Phone Mount Installation Instructions
Begin by removing the small trim bezel that surrounds the radio. This bezel has four clips that hold it in place in each corner. Carefully use the dash trim panel tool and insert it in behind the bezel in the lower right corner. Note: Be careful not to mar the soft plastic that the bezel is made of when using the dash trim panel tool. Pull back toward you to release the lower right clip. Perform this same action in the other remaining three corners of the bezel. When the bezel is loose set it aside.
Locate and remove the lower right Phillips head screw that holds the radio in place. Place the Custom Bezel Mount over the screw hole and re-install the factory Phillips screw and tighten. Note: Use the hole on the face of the mount to gain access to the Phillips screw to tighten when using the Phillips screwdriver.
Note: The space between the bezel and the radio is very tight where the mount is sandwiched between. You may need to adjust the bezel as far right as you can when securing the bezel back into place. This will allow for enough clearance. Replace the radio trim bezel securing all four clips.
Install any Bracketron phone holder or Amps compatible device to your Bezel Mount.
Your installation is complete.
Get pdf 2003-2007 Honda Element Bracketron Phone Mount Installation Instructions
