2001 CR-V Security System Kits Installation Instructions
Adjusting the Control Unit
• Use a small flat-tip screwdriver to change the mode switch and the horn/siren switch and to adjust sensitivity
Mode Switch:
• Set the mode switch according to the customer’s choice.
• Refer to the Owner’s Manual for the explanation of each mode.
Horn/Siren Switch:
• Set the switch to “HORN” in normal use. If an optional siren is installed, set the switch to “SIREN.”
Glass Breakage Sensor:
• Do not attach anything like scotch tape over these holes; this is the microphone pick-up.
Sensitivity:
• Adjust the sensitivity only if the customer requests it; the sensitivity adjustment of the glass break sensor is factory set.
• Be careful when you adjust the sensitivity; if you raise the sensitivity too much, the security system can give you a false alarm, and if the sensitivity is too low, the security system may not work even if glass is broken.
INSTALLATION
Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
1. If equipped, make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the driver’s dashboard lower cover (two self-tapping screws, four retaining clips, and one connector)
Get pdf 2001 CR-V Security System Kits Installation Instructions
