2009 TSX Front Aero Bumper Installation Instructions
The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
NOTE:
• Be extremely careful not to damage the body.
• To prevent damage, rest the front bumper on a blanket or cardboard during the installation.
• Before removing parts, note their locations so that they can be reinstalled in their original locations properly.
1. Open the hood and remove the radiator cover (eight clips).
2. Remove the two self-tapping screws, ten short clips, and two long clips from the front bumper.
3. Release the eight tabs on one side of the vehicle, and pull the front bumper toward you. Release the eight tabs on the other side of the vehicle the same way.
4. Remove the front bumper (unplug the two fog light connectors).
• Have an assistant help you when removing and installing the front bumper.
• Place the front bumper on the blanket to prevent damage.
5. Remove induction plate A from the front bumper (four clips and five bolts).
6. Remove the center induction plate from the front bumper (five self-tapping screws, four clips, and four retaining tabs).
7. Remove the left fog light from the front bumper (three self-tapping screws). Remove the right fog light the same way.
Get pdf 2009 TSX Front Aero Bumper Installation Instructions
