2003 RSX Side Under Spoiler Installation Instructions
1. Attach the left strake to the side under spoiler using the three self-tapping screws.
2. Remove the three self-tapping screws that fasten the front inner fender to the fenderwell.
3. Remove the four clips that fasten the existing side under spoiler to the side sill, then remove the spoiler by sliding it toward the front.
4. Remove the spring nut from the end of the side under spoiler you just removed.
5. Remove the eight clips from the side sill by turning them 45 degrees.
6. Slide the eight clips removed in step 5 onto the holders on the new side under spoiler through the slots shown. Slide a rubber spacer onto each of the eight clips you just installed.
7. Reinstall the spring nut removed in step 4 on the end of the new side under spoiler.
8. From the center of the rear clip hole, measure 47 mm forward, and mark that point using a felt- tip pen. Position the template on the side sill and align it with the mark you made. Continue to mark the side sill as indicated on the template, and lightly center-punch the mark.
9. While wearing eye protection, drill a 10 mm hole through the center-punched mark.
• Wrap masking tape around each drill bit at a point 10 mm from the tip of each drill bit.
• First drill with a 3 mm drill bit, then with a 6 mm drill bit, and finish with a 10 mm drill bit.
• Remove all burrs and metal shavings, and apply touch-up paint to the edges of the hole.
Get pdf 2003 RSX Side Under Spoiler Installation Instructions
