Yamaha & Honda MasterGuard Hub Kit 12 Installation Instructions
Before servicing propeller, be sure the engine is in neutral with ignition off or disconnected to avoid any possibility of the engine starting and causing injury.
Do not install any propeller without a thrust washer in place. If a thrust washer is not used, severe damage could occur to the propeller and/or engine drive.
(If you have any questions, please contact your Dealer or call our Customer Service Department.) For Yamaha® and Honda® outboards:
1) Make sure your OEM thrust washer is in place. Clean and grease the splines of the prop shaft. (Any marine grade grease is acceptable.)
2) Slide HUB ASSEMBLY into PROPELLER HOUSING from the front.
3) Slide the PROPELLER ASSEMBLY on the prop shaft.
4) Slide the PROP NUT SPACER #12050 onto the propeller assembly before prop nut.
5) Tighten prop nut according to your Engine Owner’s Manual for proper prop nut torque and fit specifications.
Get pdf Yamaha & Honda MasterGuard Hub Kit 12 Installation Instructions
