Honda 300EX Frame Skid Plate H937022 Installation Instructions
Preparation:
a) Set/Lock rear parking brake, turn gas petcock to the Off position and stand bike upright so it is sitting on the rear grab bar. Ensure bike is stable to prevent falling over during installation.
Installation:
a) One Top Slotted Hole Mount:
Press Skid Plate against the bike to temporarily hold in place.
From the bottom side install (1) #4 Washer and (1) #3 Bolt.
From the top side install (1) #2 Hook
Loosely tighten to hold skid plate in position.
b) Four Dimpled/Slotted Hole Mounts located under Top Slotted Hole Mount:
Install following Hardware for “each” of the (4) Dimpled Slotted Hole Mounts:
From the bottom side, install (1) #5 Bolt
From the top side, install (1) #6 1/8″ Spacer, (1) #7 1/4″ Spacer and (1) #8 Nylon Washer.
NOTE: The #8 Nylon Washer will “hold” the 1/8″ & 1/4″ spacers on the threaded shaft during installation.
c) Working from the bottom up, tighten all bolts to a minimum of 15 ft-lbs.
4. Maintenance: Periodically, check all fasteners for tightness and re-torque as required.
5. Care and Cleaning: Use Scotch Brite Pads (rub in one direction), to restore original line grain finish as required.
Get pdf Honda 300EX Frame Skid Plate H937022 Installation Instructions
