92-01 Honda Prelude Rear Kit Part Installation
Always keep safety in mind when working on your vehicle. Completely read these instructions before installing the kit.
I. Preparing the Vehicle
1. Jack the vehicle up and support the body on jackstands.
2. Remove the rear wheels (Figure 1).
II. Strut Removal
1. Remove the bolt in the lower strut mount and discard (Figure 2).
2. Remove the two nuts from the upper strut mount and retain for re-installation.
NOTE: These are located behind the back seats in the trunk compartment on the inside of the vehicle.
3. Remove strut assembly.
4. Using a spring compressor, remove the O.E.M retaining nut, 1 flatwasher, and the rubber bushings from the upper strut mount (Figure 3). Retain the flat washer and rubber bushing for later use.
III. Cutting the Upper Strut Mount
1. Make a relief cut on the mount (Figure 7) to allow adequate clearance for the air fitting.
NOTE: Failure to cut this relief will cause serious damage to the air fitting.
2. Once upper mount modifications are complete, reinstall the upper strut mount to its O.E.M. position using the previously removed O.E.M. upper strut mounting hardware.
Get pdf 92-01 Honda Prelude Rear Kit Part Installation
