2009 Civic 2 AND 4-Door Aluminum Wheel Instructions
1. Clean the mating surface and the valve hole of the aluminum wheel.
2. Install the tire pressure sensor and the washer to the aluminum wheel, and loosely install the valve nut. Make sure the pressure sensor is resting on the wheel.
NOTE: Install the tire pressure sensor so that the sensor housing surface should not exceed the wheel protrusion to prevent the sensor housing caught to the bead of the tire when assembled the tire.
3. Tighten the valve nut to the specified torque while holding the tire pressure sensor toward the wheel.
Tightening torque: 4 N·m (0.4 kgf·m, 3 lbf·ft)
NOTE:
• Do not reuse the grommet that had been tightened, even one time, to the specified torque, as they are deformed inside.
• Do not use pneumatic or electric tools on the valve nut.
• Tightening the nut to the specified torque or above can damage the grommet.
4. Install the tires according to the instructions in the Service Manual.
5. Install the wheels on the vehicle and torque to 108 N·m (80 lbf-ft).
6. Open the driver’s door. Using isopropyl alcohol, clean the area where the accessory tire pressure caution label will attach. Remove the backing from the label and attach it over the existing tire information label. Attach the tire pressure caution label or label C or label D according to the following information:
Label: For EX-L Model with a T125/70D15 95M
Label C: For EX-L Model with a T135/80R16 101M
Label D: For EX-L Model with a T135/80D16 101M
7. Attach the “Supplemental Information” page included in this kit to the Owner’s Manual. For the method of attaching the page, refer to “To the dealer:” attached to the “Supplemental Information” page.
MEMORIZING THE TIRE PRESSURE SENSOR ID
8. Using the HDS and Snap-on TPMS sensor initializer tool, memorize the ID of tire pressure sensor ID according to the instructions in the Service Manual (Memorizing the Tire Pressure Sensor ID).
Get pdf 2009 Civic 2 AND 4-Door Aluminum Wheel Instructions
